Crosley Conservator CEDC392JQ Use & Care Manual page 6

Recommended/Minimum Clearances
Most i nstallations require
• minimum 5 in. (12.7 ore) clearance
behind the dryer for the exhaust vent with elbows. See "Venting
Requirements."
NOTE: Observe all governing codas and ordinances.
f
cm)
?Height with casters is 32½" (82.6 cm).
Recessed Area and Closet Installation
Your dryer needs • certain •mount of space around it for proper
ventilation and for easier inst•llstion and servicing. The following
minimum installation spacings •re required when the unit is to be
operated with, or without, the Stack Stand Kit. To pumhase •
Stack Stand Kit, see "Asaist•nce or Service."
Minimum installation spacing
38.6 Cl
18"( .
IDRYEF
1 2
(30.5 cm)
DRYER
12 = _
WASHER
*'*' "_-I1<- _=114_'*'1 =
(2.5cm) 4 (2,5m)
5
1. Side 4. Front--stack stand
2. Front 5. Side--stack stand
3. Closet door
* Additional space may be needed for exhaust elbow
** Opening is minimum for closet doo_ Louvered
door with air opening is acceptable.
*** May be O" (0 cm) clearance
Additional spacing should be considered for ease of
installation and servicing.
Additional cl••rancas might be required for wail, door, and
floor moldings.
Additional spacing of 1 in. (2.5 ore) on all sides of the dryer is
recommended to reduce noise transfer.
For classt installation with • door, minimum ventilation
openings in the top and bottom of the door •re required.
Louvered doors with equivalent ventilation openings are
•coept•ble.
•
Companion appliance spacing should •leo be considered.
NOTE: No fuel-burning appliances may be installed in the same
closet as • dryer.
Mobile Home-Additional Location Requirements
This dryer is suitable for mobile home inst•llstione. Follow the
information in "Location Requirements."
The installation must conform to the Manufactured Home
Construction and Safety Standard, Title 24 CFR, Part 3280
(formerly the Federal Standard for Mobile Home Construction
and Safety, Title 245, HUD Part 280).
6