Washer Maintenance - Whirlpool cabrio Use And Care Manual

9. Select cycle options
Deep Delay
Clean Wash
I Loud
m mid _ am _ Soft
EcoBoost Presoak Extra Fabric Cycle
Rinse Softener Signal
Select any other cycle options you may wish to add, if not
previously set. Some cycles will automatically add certain
options such as Deep Clean or Extra Rinse. These can be
turned off, if desired.
NOTE: Not all options are available with all cycles.
1 O, Press START/Pause/Unlock to
begin wash cycle
CD
START
Pause/Unlock
Press the START/Pause/Unlock button to start the wash cycle.
When the cycle has finished, the DONE indicator will light and
the end of cycle signal will sound (if set).
Promptly remove garments after cycle has completed to
avoid odor, reduce wrinkling, and rusting of metal hooks,
zippers, and snaps.
Unlocking the lid to add garments:
If you need to open the lid to add 1 or 2 c_
missed garments:
Press START/Pause/Unlock; the lid will unlock
once the washer movement has stopped.
This may take several minutes if the load Pause/Uo=ock
was spinning at high speed. Then close
lid and press START/Pause/Unlock again
to restart the cycle.
If lid is left open for more than 10 minutes the water will
pump out automatically.
START
WASHER r INTENANCE
r
WATER INLET HOSES
Replace inlet hoses after 5 years of use to reduce the risk
of hose failure. Periodically inspect and replace inlet hoses
if bulges, kinks, cuts, wear, or leaks are found.
When replacing your inlet hoses, mark the date of
replacement on the label with a permanent marker.
f CLEANING YOUR WASHER
Keep your washer as clean and fresh as your clothes.
To keep washer interior odor-free, follow this recommended
monthly cleaning procedure:
1. Make sure the washer is empty.
2. Using recommended AFFRESH ® washer cleaner,
add one tablet to washer drum
OR
If using liquid chlorine bleach, add 1 cup (250 mL) to
liquid chlorine bleach dispenser.
IMPORTANT: Do not add detergent to CLEAN WASHER
with AFFRESH TM cycle. Do not use more than recommended
amount of bleach to avoid damaging product over time.
3. Close washer lid.
4. Press POWER.
5. Select CLEAN WASHER with AFFRESH TM cycle.
6. Press START/PAUSE. Water will pour into washer
for a moment and pause, lid will lock, then cycle
will continue.
NOTE: For best results, do not interrupt cycle. If cycle must
be interrupted, press START/Pause/Unlock twice and run
a RINSE AND SPIN cycle to ensure cleaner or bleach have
been rinsed from washer.
To clean exterior:
1. Use a soft, damp cloth or sponge to wipe up any spills.
2. Use all-purpose surface cleaner, if needed.
IMPORTANT: To avoid damaging the washer's finish,
do not use abrasive products.
10