Enhancements/Extras - GE Triton XL GSD6900 Owner's Manual

ge.com
SPEED CYCLE
CHINA CRYSTAL
GLASSES
(on some models)
RINSE ONLY
Heavy 7.8 gal., 37 min.
Medium 6.5 gal., 33 min.
Light 5.2 gal., 29 min.
This cycle is for everyday dishes and glassware.
Heavy 9.1 gal., 52 min.
Medium 7.8 gal., 45 min.
Light 6.5 gal., 38 min.
This cgcle is for lightly soiled china and crystal.
Heavy 9.1 gal., 49 min.
Medium 7.8 gal., 42 min.
Light 6.5 gal., 40 min.
This cycle is specifically designed for glasses.
Heavy 2.6 gal., 7 min.
Light 1.3 gal., 4 min.
For rinsing partial loads that will be washed later. Do not use detergent with this cycle.
NOTE:This dishwasher is equipped with an ExtraClean
TM
Sensor with automatic temperature control;
therefore cycle length and time may vary depending on soil and temperature conditions.
NOTE:Only the Anti-Bacteria cycle has been designed to meet the requirements of Section 6, NSF 184 for
soil removal and sanitization efficacy.
_]l Enhancements/Extras
The light above the selected pad will be ON to indicate which ENHANCEMENT/EXTRA has been selected.
PREWASH For use with heavily soiled and/or dried-on, baked-on soils. This option MUST be
(on some models) selected PRIORto starting the cycle. This option adds 16 minutes to the cycle time.
NOTE:Cannot be selected with RINSEONLY cycle.
HEATED DRY Shuts off the drying heat option. Dishes air dry naturally and energy is saved. For
Light OFF faster air dry, you can prop the door open after the CLEAN light illuminates.
HEATED DRY Turns the heater on for fast drging. This will extend the time to your wash cgcle bg 8
Light ON minutes for the SPEEDCYCLEand 30 minutes for all other cgcles. NOTE: Cannot be
selected with RINSEONLY cgcle.
LOCK
ADDED HEAT or
EXTRAHOT WASH
(on some models)
You can lock the controls to prevent any selections from being made. Or you can lock
the controls after you hove started o cycle.
Children cannot occidentally start dishwasher by touching pods with this option
selected.
To unlock the dishwasher controls, touch and hold the HEATEDDRY pad for 3 seconds.
To lock the dishwasher, touch and hold the HEATEDDRY pad for 3 seconds. The light
above the LOCK pad will turn off.
When selected, the cgcle will run longer with heating elements on to improve both
wash and dry performance. NOTE:Cannot be selected with RINSEONLY cgcle.
DELAY HOURS
RESET
You can delag the start of a wash cgcle for up to 9 hours. Touch the DELAYHOURSpad
to choose the number of hours you want to delag the start of the cgcle; then touch
START/RESET. The machine will count down and start automatically at the correct time.
Touching START/RESET a second time will cancel the DELAYSTARTselection. NOTE:If
you forget to fully close the door, a reminder signal will beep until you do so.
To change a cgcle after washing starts, touch the START/RESET pad to cancel the
cgcle. The START/RESET light will flash while the water is pumped out if needed. This
takes approximately 90 seconds. When the light stops flashing, the dishwasher can be
reprogrammed and restarted.