Advertisement
ICE PRODUCTION:
WHATTO
EXPECT
How Much ice Will a Side Mounted ice Maker Produce in 24
Hours?
A side mounted ice maker will produce 4 to 4.5 pounds of ice
every 24 hours, depending on usage conditions. Ice is produced
at a rate of 8 cubes every 75 to 90 minutes.
How Much Ice Will a Rear Mounted Ice Maker Produce in 24
e
Hours?
A rear mounted ice maker will produce 3 to 4 pounds of ice
every 24 hours, depending on usage conditions. Ice is produced
at a rate of 8 cubes every 75 to 90 minutes.
ICE AND WATER
DISPENSER
FEATURES
The ice and water dispenser conveniently
dispenses chilled
water, and ice cubes or crushed ice, depending on the model.
To operate the ice dispenser, select the ice option desired using
the touchpad. Press a glass against the dispensing paddle as
far up as possible to catch all ice. To stop dispensing ice, pull
glass away from dispensing paddle. Do not remove the glass
until the ice has completely dispensed. Complete instructions
for the dispenser operation are attached to the inside of the
freezer door (some models).
if the dispensing paddle is pushed for more than four
minutes,
the dispenser motor may overload and stop; The
overload
protector will reset automatically
after three or
four minutes_
Remove ice container by lifting up and out. Empty and
carefully clean the container with mild detergent. Rinse
with clear water. Do not use harsh or abrasive cleaners.
Allow ice container to dry completely before replacing in
the freezer.
Remove ice chips and clean the shelf and chute that
supports the ice container.
Replace the ice container. Resume ice production on
side-mounted
ice makers by lowering the wire signal
arm to the DOWN position. Resume ice production on
rear-mounted
ice makers by pressing the ice maker's
On/Off power switch to the On (I) position.
Do not use the ice chute as a handle when removing
or replacing the ice storage bin: Surfaces there may be
sharp, Do not put fingers
up ice chute. Surfaces there
may be sharp,
ICE DISPENSER
TIPS
Ice cubes stored too long may develop an odd flavor.
Empty the ice container and ensure that the ice maker is
on (see previous page). The ice maker will then produce
more ice.
•
Occasionally shake the ice container to keep ice
separated.
•
If a large quantity of ice is needed at one time, it is best
to remove cubes directly from the ice container.
•
Stop the ice maker when cleaning the freezer and during
vacations.
•
If the ice maker will be turned off for a long period of
time, turn the water supply valve to a closed position.
CLEANING
THE ICE DISPENSER
Clean the ice dispenser and ice container at regular intervals,
particularly before you take a vacation or move, or if the ice
dispenser sticks.
•
Stop ice production on side-mounted
ice maker by
raising wire signal arm to the UP position. Stop ice
production on rear-mounted
ice makers by pressing the
ice maker's On/Off power switch to the Off (O) position.
When removing or replacing the ice bin, DQ NOT rotate
the auger in the ice bin_ If the auger iS accidenta!lY rotate d,
you must rea!ign the auger by turning it in 90 ° turns unti!
the ice bin fits into place with the drive mechanism, if the
auger iS not properly aligned whe n replacing the ice bin, the
refrigerator w!ll oniy d!spens e Crushed !co. The freeze[ door
may a!so not c!ose proper!y causing warm a!r to leak into the
freezer.
•
An extended power failure (one hour or longer) causes
ice cubes in the ice storage bin to melt and freeze
together and jam the dispenser mechanism.
•
The ice dispenser is not used frequently. Ice cubes will
freeze together in the bin and jam the dispenser
mechanism. Remove the ice storage bin and shake to
loosen the cubes.
NEVER use an ice pick or simila r sharp instrument to
break upthe
ice, This could damage the ice storage bin
and dispenser
mechanism.
17
Advertisement
