Wireless Lan Menu - Epson EMP EMP-1825 User Manual

List of Functions

Wireless LAN Menu

f
Sub Menu
Connection mode Sets connection mode to be used for establishing connection using EMP NS Connection.
Set "Quick" when you want to quickly establish a wireless connection. Set "Advanced" to connect to the network system via an access point.
Setup by WPS When a WPS-compatible device is being used via an access point, this mode allows you to make the connection settings easily. When you position
the cursor to "To Setup Wizard" and press [Enter] button, the WPS setting screen is displayed. As the setting method, select either "Push Button
Method" or "PIN Code Method".
Antenna level Displays the wireless LAN wave strength.
Wireless LAN Sets the wireless LAN system.
system
SSID g Enter an SSID. When an SSID is provided for the wireless LAN system in which the projector participates, enter the SSID. The initial value is EPSON.
You can enter up to 32 single-byte alphanumeric characters.
DHCP g You can set whether to use DHCP (On) or not (Off).
If this is set to "On" you cannot set any more addresses.
IP address g You can input the IP address assigned to the projector.
You can enter a number from 0 to 255 in each field of the address. However, the following IP addresses cannot be used.
0.0.0.0, 127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x is a number from 0 to 255)
Subnet mask g You can input the subnet mask for the projector. You can enter a number from 0 to 255 in each field of the address. However, the following subnet
masks cannot be used.
0.0.0.0, 255.255.255.255
Gateway address g You can input the IP address for the gateway for the projector.
You can enter a number from 0 to 255 in each field of the address. However, the following gateway addresses cannot be used.
0.0.0.0, 127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x is a number from 0 to 255)
MAC Address
Indicates the MAC Address.
SSID Display To prevent the SSID from being displayed on the Standby screen, set this to "Off".
IP Address Display To prevent the IP address from being displayed on the Standby screen, set this to "Off".
Function
51