Replacing The Lamp - Epson EMP 8200 Owner's Manual

Replacing the Lamp

Replace the lamp at the following times (model number: ELPLP11).
When a message stating [Lamp Replace] is displayed for thirty seconds after
the start of projection
When the lamp indicator is blinking in orange
When the brightness and picture quality has deteriorated below the initial
levels
Point
· Replace the lamp as quickly as possible after the message has been displayed to main-
tain the initial brightness levels and picture quality.
· The replacement message has been set at approximately 1,900 hours of use in order to
maintain the initial brightness levels and picture quality. If you continue to use the lamp
after this period, the possibility of the lamp breaking becomes greater. When the lamp
replacement message appears, replace the lamp with a new one as soon as possible,
even if it is still working.
· Although the replacement message is displayed after approximately 1,900 of use, there
are cases where the individual characteristics of each lamp and other usage conditions
result in it not lighting up before this 1,900 hours has elapsed. For this reason, always pre-
pare a replacement lamp well in advance.
· Contact your dealer for a spare lamp.
84 - Replacing the Lamp
Lamp Replace
The lamp indicator will blink in orange.