Table of Contents
Advertisement
Correcting Computer Images
If you've connected a computer and the image doesn't look right, or it
doesn't fit properly on the screen, press the
projector or the
Enter/Auto
automatically resets the projector's tracking, sync, resolution, and
position settings. You must be projecting a computer image for this
button to have any effect. Additionally, if the
the Signal menu is set to
page 55.
Adjusting the Volume
You can use the
and
Vol-
increase or decrease the volume for the projector's built-in speaker.
You can also use the buttons on the projector to control the volume.
Press the
button to increase the volume, or the
decrease it. A volume gauge appears on the screen while the volume is
being adjusted.
Enter
button on the remote control. This
Auto Setup
, the Auto function will not work. See
Off
buttons on the remote control to
Vol+
Volume control
buttons
button on the
option in
button to
note
You can also adjust the
volume using the projector's
Settings menu. See page 56
for details.
You must adjust the volume
separately for each input
source.
Projecting
41
Advertisement
Table of Contents
