PowerLite 822p/83c Projector Control Panel Projector Parts Opens menu system Up/down arrows and Turns projector keystone correction on and off Security slot A/V mute slide Cancel/exit Control panel Zoom ring Lamp cover Focus ring Opens help Indicate system projector status exhaust Left/right arrows and vent...
Page 2
PowerLite 822p/83c Projector Keystone Safety and Approvals ± correction angle 30° vertical (maximum) United States FCC Part15B Class B (DoC) UL60950-1 Projection Lamp Canada ICES-003 Class B Power consumption 170 W UHE CSA C22.2 No. 60950-1 Lamp life About 3000 hours (High brightness); 4000 hours (Low brightness) Compatible Video Formats Note:...
PowerLite 822p/83c Projector Positioning the Projector Refresh Rate Mode (Hz) Resolution VGA EGA 640 × 350 Follow these guidelines to get the best results when projecting: VGA—60 640 × 480 ❏ Place the projector on a sturdy, level surface, between VESA—72 640 ×...
Power button For more help determining the size of your image or where to position the projector, try the Image Size Calculator on the Drivers and Downloads page for your projector on Epson’s website. Turning On the Projector Make sure your projector and other equipment are set up and connected correctly.
PowerLite 822p/83c Projector To focus and adjust the image, see page 6. If a projected image If you’re using a PC laptop: fails to appear, see “What To Do If You See a Blank Screen” ❏ Hold down the key and press the function key that lets below.
Note: ® With Epson’s exclusive Instant Off technology there’s no cool- down period, so you can pack up and go immediately after turning off the projector. (If you want to turn the projector on again, press the button.)
PowerLite 822p/83c Projector Adjusting the Image Shape Adjusting the Volume If the projector is tilted up or down, the images that are You can use the – and + buttons on the remote control displayed will be distorted. To correct the distortion or to increase or decrease the volume for the projector’s built-in “keystone”...
PowerLite 822p/83c Projector The following table lists the color modes available. Stopping Action Press the button to Freeze Color mode Description stop the action in your video Photo Best for projecting still images with vivid color or computer image and keep in a bright room (computer input only).
If you continue to use the lamp, there is a risk it may break. Flashing There is a problem with the fan or a sensor. Turn the projector off and unplug it. Contact Epson for help. 3/08 PowerLite 822p/83c Projector...
Description Selects another There is an internal error in the image source projector. Turn the projector off Turns and unplug it. Contact Epson for projector help. on or off Cancels current function or displays previous menu or screen...
3. Replace the battery cover. Make sure it clicks into place. the power cord. 2. To clean the filter and vent, Epson recommends using a small vacuum cleaner designed for computers and other office equipment. If you don’t have one, gently clean them using a very soft brush (such as an artist’s paintbrush).
Info menu. If the dirt is difficult to remove or if the filter is torn, replace Contact your dealer or call Epson at (800) 463-7766 for a it. Contact your dealer or call Epson at (800) 463-7766 to replacement lamp.
PowerLite 822p/83c Projector 5. Use the screwdriver to loosen the two screws holding the 8. Once the lamp is fully inserted, tighten its screws. lamp in place. (You can’t remove the screws.) Don’t remove these screws 9. Lower the lamp cover into place. (The opening should be almost covered, and the top of the cover should be flush with the top of the projector.) Then slide the cover closed 6.
To purchase a replacement remote control, call (562) 276-4394 ❏ When you are hand-carrying the projector, be sure to use a (U.S.) or (905) 709-3839 (for dealer referral in Canada). carrying case. Note: Epson shall not be liable for any damages incurred during transportation. PowerLite 822p/83c Projector 3/08...