Table of Contents
Advertisement
F!
Gm
• o' InTfreezing weather oil will thicken, making it
._°-_h_b_e:ssary to thin barand
chain oil with a
small amount of Diesel Fuel #1 or Kerosene.
Bar and chain oit must be free flowing
for the
oil system
to pump enough oil for adequate
lubrication.
1_ _E
THE FOLLOWING:
30°F
or above--Lubricant--undiluted.
30°F- 0°F
--95%
Lubricant
to
, ,_;.!_'_, :_
5% Diesel Fuel #1
or Kerosene.
Below 0°F
--90%
Lubricant
to
10% Diesel Fuel #1
or Kerosene.
2. HOWTO
FILL THE OIL TANK
a. Turn-saw
on its side with oil cap up. Figure
14.
b. Loosen cap slowly; wait for pressure,in
the
tank to be released
before
removing
the
:
cap.
c. Fill the oil tank,
d. Replace the oil cap securely,
BAR AND
CHAIN
OIL
• The guide bar and cutting chain require con-
stant
lubrication
in order
to
remain
in
operating condition, Lubrication is provided
by the automatic
oiler system
when the oil
tank is kept filled.
--Lack
of oil will quickly ruin the bar and
chain,
--Too
little oil will cause overheating shown
,by smoke
coming from the chain andJor
,discoloration
of the guide bar rails.
e Use SEARS Bar and Chain Lubricant #36554
or clean SAE 3OW oil,
3. IMPORTANT
POINTS
a. Fill the oil tank each time you refill the fuel
tank to ensure there will be sufficient
oil for
the chain whenever
you start and Fun the
saw.
OIL •
CAP
b, it is normal for a Small amount of oil;to ap-
pear under the saw after the engine, stops
due to oil draining from the bar and _hain.
Figure 14
OPTIONAL
MUFFLER,
HEAT
SHIELD:ASSEMBLY
•The following
instructions
have been included
to help you install the optional
Muffler
Heat
Shield ,Kit,_ Repair
Part No. 69037. This kit will
REMOVE STANDARD
MUFFLER
pf.o_(_, you_ saw with a_temperatureolimiting
•muffle/" which may be re:quired by law in some
states;,See
State and Local Ordinances, page 4
for_further
information.
1. Remove the screw located in the center of the
-muffler
body. Figure 15.
2. Rem_o_e the muffler
cover
from the muffler
b_dy'and
discard.
NOTE: Do not remove other muffler
parts. If
.other
parts
are
removed,
see
muffler
as*
sembly
in Figure 46, page 19.
3. Install
the temperature
limiting
muffler
body.
Figure 16.
4. Replace screw and tighten
securely.
JCAUTION:i Do not use an air wrench to tighten
the screw as parts can become overtightened
and damage
can occur,
INSTALL
HEAT
sH i E LD COVE R
F{gure 15
Figure 16
i i
9
Hide quick links:
Advertisement
Table of Contents
