Advertisement
Keys
Slope Sheet
(2) Keys
(1) Oil Drain Tube
For Future Use
Your new tractor has been assembled at the factory with exception of those parts left
unassembted for shipping purposes.
TOOLS REQUIRED FOR ASSEMBLY
A socket wrench set will make assembly
easier. Standard wrench sizes are listed.
(1) 1/2" wrench
Tire pressure gauge
(2) 7/16" wrenches
Utility knife
Pliers
When right or left hand is mentioned
in
this manual, it means when you are in the
operating position (seated behind the steer-
ing wheel).
TO REMOVE TRACTOR FROM
CARTON
UNPACK CARTON
•
Remove all accessible
loose parts and
parts cartons from carton.
Cut along dotted lines on all four panels
of carton. Remove end panels and lay
side panels flat.
Check for any additional loose parts or
cartons and remove.
TO ADJUST SEAT
•
Sit in seat.
•
Lift up adjustment lever (A) and slide seat
until a comfortable
position is reached
which allows you to press clutch/brake
pedal all the way down.
•
Release lever to lock seat in position.
BEFORE
REMOVING
TRACTOR
FROM
SKID
TO CHECK BATTERY
1. Lift seat to raised position.
NOTE: If this battery is put into service after
month and year indicated on label (label is
located between terminals) charge battery
for minimum of one hour at 6-10 amps. (See
"BATTERY" in Maintenance
section of this
manual for charging instructions).
For battery and battery cable installation
see "REPLACING
BATTERY"
in the
"Service and Adjustments" section in this
manual.
NOTE: You may now roll your tractor off
the skid. Follow the instructions
below to
remove the tractor from the skid.
_i, WARNING:
Before starting, read, un-
derstand and follow all instructions
in the
Operation section of this manual. Be sure
tractor is in a well-ventilated
area. Be sure
the area in front of tractor is clear of other
people and objects.
Advertisement
