To Roll Tractor Off Skid; To Drive Tractor Off Skid; Install Seat - Craftsman EZ3 917.272201 Owner's Manual

INSTALL SEAT
Adjust seat before tightening adjustment
knob,
• Remove adjustment knob and flat
washer securing seat to cardboard
packing and set aside for assembly of
seat to tractor.
• Pivot seat upward and remove from
the cardboard packing. Remove the
cardboard packing and discard°
• Place seat on seat pan and assemble
shoulder bolt. Tighten shoulder bolt se-
curely.
• Assemble adjustment knob and flat
washer loosely. Do not tighten.
° Lower seat into operating position and
sit on seat.
• Slide seat until a comfortable position
is reached which allows you to press
clutch/brake pedal all the way down.
, Get off seat without moving its adjusted
position.
° Raise seat and tighten adjustment
knob securely.
Seat
Shoulder Seat Pan
Flat Washer
Adjustment
Knob
NOTE: You may now roll or drive your
tractor otf the skid. Follow the appropriate
instruction below to remove the tractor from
the skid.
TO ROLL TRACTOR OFF SKID (See
Operation section for location and
function of controls)
• Press lift lever plunger and raise at-
tachment lift lever to its highest posi-
tion.
• Release parking brake by depressing
clutch/brake pedal.
• Place freewheel control in freewheel-
ing position to disengage transmission
(See "TO TRANSPORT" in the Opera-
tion sectio_n o1 this manual).
• Roll tractor forward off skid°
TO DRIVE TRACTOR OFF SKID
(See Operation
section for location
and function of controls)
• lk WARNING: Before starting, read, un-
derstand and follow all instructions in the
Operation section of this manual. Be sure
tractor is in a well-ventilated area. Be
sure the area in front of tractor is clear of
other people and objects.
• Be sure all the above assembly steps
have been completed.
° Check engine oil level and fill fuel tank
with gasoline.
, Place freewheel control in 'lransmis-
sion engaged" position.
• Sit on seat in operating position, de-
press clutch/brake pedal and set the
parking brake.
• Place motion control lever in neutral
(N) position.
• Press lift lever plunger and raise at-
tachment lift lever to its highest posi-
tiono
• Start the engine. After engine has
started, move throttle control to idle po-
sition.
• Release parking brake.
• Slowly move the motion control lever
forward and slowly drive tractor off
skid.
, Apply brake to slop tractor, set parking
brake and place gearshift lever In neu-
tral position.
• Turn ignition key to "OFF" position.
Continue with the instructions that follow.
8