Table of Contents
Advertisement
■
Try reconnecting both ends of your cable.
■
Make sure your video equipment is on. If it isn't, turn the projector off, then turn it on
again after you've turned on your video equipment.
You see a screen with the message
■
Make sure your video equipment is turned on.
■
Make sure your cable(s) are connected correctly, as described in the Quick Setup sheet.
■
Press the
Source
the remote control to select the correct input source. Allow a few seconds for the
projector to sync up.
■
Check the settings in the
make sure they're correct for your video equipment. See page 22 for details.
If you're using a PC laptop:
■
Press the function key that lets you display on an external monitor. It's often labeled with
an icon such as
the
key while pressing it. Check your laptop's manual or online help.
Fn
On most systems, the
projector, or display on both at the same time. Allow a few seconds for the projector to
sync up after pressing it.
■
Depending on your computer's video card, you might need to use the Display utility in
the Control Panel to make sure that both the LCD screen and external monitor port are
enabled. See your computer's documentation for details.
If you're using a Macintosh laptop with OS X:
1. Select
System Preferences
2. Click
Detect Displays
3. To display the entire desktop on both your projector screen and LCD screen, click
the
Arrange
window.)
No Signal
button on the projector or the
Video Signal
, but it may also be labeled
key lets you toggle between the LCD screen and the
from the Apple menu and click
.
tab. (If you don't see this tab, make sure it isn't hidden by another
displayed.
or
Input A/B
S-Video/Video
and
options in the Setting menu to
Input A
. You may have to hold down
CRT/LCD
buttons on
.
Displays
33
Advertisement
Table of Contents
