Container Mounting; Lower Chute - Craftsman 917.249740 Owner's Manual

CONTAINER MOUNTING (See Fig. 6)
No hardware required
• Install one container to left side first with warning to
outside of unit. Install another container to center
position and one in right position.
NOTE: Right container should always overlap left container
at center supports.
• Close cover and lock latch handles over center support
tubes.
COVER LATCH
HANDLES
CONTAINER
WARNING
CENTER
TUBES
CONTAINER
HANDLE
CONTAINER
WARNING
FIG. 6
LOWER CHUTE
(See Fig.
7A &
7B)
Use
Hardware --
GROUP "D"
• Press weld nut into rubber latch and install two latch
hook assemblies to lower chute using screw, washer,
and lock washer as shown.
• Tighten hardware securely.
• Raise and hold deflector shield in upright position.
• Place rear of chute over rear of mower deck opening.
Push chute down and forward to guide extended edge of
chute between discharge guard and mower deck.
• Hook front latch into tab hole on front of mower deck.
• Hook rear latch intoflange hole on back of mower deck.
CAUTION: Do not remove discharge J
guard from mower. Raise and hold guard
when attaching lower chute and allow it
to rest on chute while in operation.
LOCK WASHER
jI WELO NU
FIG. 7A
\
DEFLECTOR
SHIELD
FRONT
LATCH
REAR LATCH
FIG. 7B
9