Container Assembly; Container Mounting - Craftsman 917.249790 Owner's Manual

CONTAINER ASSEMBLY (See Fig. 3)
No hardware required
Place bottom half inside of top half, as shown.
Place one foot inside bottom half and lifttop half to meet
bottom half.
Press halves tightly togetherwhile lifting top to lock into
place as shown,
IMPORTANT: BEFORE LOCKING THE TABS, HOOKED
EDGES ON BOTH HALVES MUST OVERLAP TO FORM
SEAL AS SHOWN IN INSET.
Repeat for second container.
CONTAINER
BOTTOM
HALF
CONTAINER
TOP HALF
CONTAINER
BOTTOM
HALF
PRESS TOGETHER
TO FORM SEAL
WHILE LIFTING
TOP HALF
LOCKING
TAB
ASSEMBLY CHECK: Squeeze sides of lower half of con-
tainer and check that there is no gap between upper and
lower halves. If a gap appears, unlock tabs to separate
container halves and repeat instructions above.
FIG, 3
CONTAINER MOUNTING (See Fig. 4)
No hardware required
Install one container to left side first with warning to
outside of unit. Install other container to right side.
NOTE: Right container should always overlap left container
at center support.
Close cover and lock latch handle over center support
tube.
COVER LATCH --
HANDLE
CONTAINER
WARNING
CONTAINER
HANDLE
SUPPORT
TUBE
CONTAINER
WARNING
FIG. 4