Craftsman 358.352681 Operator's Manual page 18

TROUBLE SHOOTING CHART - Continued
Chain moves • idle speed requires • See "Carburetor Adjustments."
at idle speed / adjustment,
!. Clutch requires repair • Contact Sears Service,
Chain does
not move
when engine
is accelerated
Chain clatters
or cuts roughly
Chain stops
within the cut,
Chain cuts at
an angle
Chain tension too
tight,
Carburetor requires
adjustment
Guide bar rails
pinched
Clutch slipping
• Chain tension incorrect
• Cutters damaged
• Chain worn
• Cutters dull, improperly
sharpened, or depth
gauges too high
• Sprocket worn
• Chain installed
backwards
Chain cutter tops not
flied flat
Guide bar burred or
bent; rails uneven
Clutch slipping
Cutters damaged on ......
one side.
Chain dull on one side.
• Guid_ bar bent or worn.
• See "Chain Tension"
• See "Carburetor Adjustments."
• Repair or replace.
• Contact Sears Service.
• See "Chain Tension."
• Contact SearsService.
• Resharpen or replace chain.
• See "SharpeningChain."
• Contact Sears Service.
• Install chain in right direction.
•Sea "sharpening hai ."
• Repair or replace guide bar.
• Contact Sears Service.
• See 'Sharpening Chain"
• See "Sharpening Chain."
• Replace guide bar
If situations occur which are not covered inthis manual, use care and good
judgement. If you need assistance, contact Sears Service or the CUSTOMER
ASSISTANCE HELPLINE at 1-800-235-5878,
18