Craftsman 917.255560 Owner's Manual page 18

SERVICE AN ADJUSTMENTS
CAUTION: BEFORE PERFORMING ANY SERVICE OR ADJUSTMENTS:
i_ * Depress clutch/brake pedaa fuBly and set parking brake.
o Place gearshift lever in "NEUTRAL" position.
• Place attachment clutch in "DKSENGAGED" position,
• Turn ignition key "OFF" and remove key.
o Make sure the bmadesand ag moving p_s have completely stopped,
o Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with
plug.
TRACTOR
TO REMOVEMOWER (See Fig. 17)
Mower will be .easier to remove from the right side of unit.
• Place attachment clutch in "DISENGAGED" position.
- Move attachment lift lever forward to lower mower to its
lowest position,
• Roll belt off engine pulley.
o Disconnect clutch rod from clutch lever by removing
retainer spring,
o Disconnect suspension arms from rear deck brackets
by removing retainer springs.
, Disconnect front links from deck by removing retainer
springs.
o Raise lift lever to raise suspension arms. Slide mower
out from under tractor.
iMPORTANT: IF AN ATTACHMENT OTHER THAN THE
MOWER tS TO BE MOUNTED TO THE TRACTOR. THE
R.H. AND L.H. SUSPENSION ARMS MUST BE REMOVED
FROM TRACTOR.
TO iNSTALL MOWER (See Fig, 17)
• Raise attachment lift lever to its highest position.
• Slide mower under tractor with discharge guard to right
side of tractor.
• Lower lift lever to its lowest position.
• Install mower in reverse order of removal instructions.
\
CLUTCH RF;TAIN ER
ROD SPRING
FiG. 17
ENGINE
PULLEY
i'
/
/
!8