Craftsman 917.270911 Owner's Manual page 30

TROUBLESHOOTING CHART
PROBLEM CAUSE CORRECTION
Poor cut - uneven * Clean around mandrels to
(cont'd) open vent holes.
Mower blades will • Remove obstruction.
not rotate
• Clogged mower deck vent
holes from buildup of
grass, leaves, and trash
around mandrels.
• Obstruction in clutch
mechanism.
• Worn/damaged mower
drive belt.
• Frozen idler pulley.
• Frozen blade mandrel.
• Engine speed too slow.
• Travel speed too fast.
• Wet grass.
• Mower deck not level.
• Low/uneven tire air pres-
sure.
• Worn, bent or loose
blade.
• Buildup of grass, leaves
and trash under mower.
• Mower drive belt worn.
• Blades improperly in-
stalled.
• Improper blades used.
• Clogged mower deck vent
holes from buildup of
grass, leaves, and trash
around mandrels.
• Switch is "OFF".
• Bulb(s) burned out.
• Faulty light switch.
• Loose or damaged wiring,
• Blown fuse.
• Bad battery cell(s).
• Poor cable connections.
• Faulty regulator (if so
equipped).
• Faulty alternator.
Poor grass dis-
charge
Headlight(s) not
working (it so
equipped)
Battery will not
charge
Engine =backfires"
when turning en-
gine =OFF"
• Engine throttle control not
set at uSLOW"
position for 30 seconds
before stopping engine.
• Replace mower drive belt.
• Replace idler pulley.
• Replace blade mandrel.
• Place throttle control in
=FAST" position.
• Shift to slower speed.
• Allow grass to dry before'
mowing.
• Level mower deck.
• Check tires for proper air
pressure.
• Replace/sharpen blade.
Tighten blade bolt.
• Clean underside of mower
housing.
• Replace mower drive belt.
• Reinstall blades sharp edge
down,
• Replace with blades listed in
this manual.
• Clean around mandrels to
open vent holes,
• Tum switch =ON'.
• Replace bulb(s).
• ChecWraplace light switch.
• Check widng and connec-
tions,
• Replace fuse.
• Replace battery.
• Check/clean all connections,
• Replace regulator.
• Replace alternator,
• Move throttle control to
=SLOW" position and allow
to idle for 30 seconds before
stopping engine.
30