Belt Installation - Craftsman 917.270911 Owner's Manual

BELT INSTALLATION -
• Install new belt in reverse order of
removal.
• Make sure belt is in all pulley grooves
and inside all bolt guides.
• Install mower in reverse order of
removal instructions.
Mandrel
Idler Pulleys
TO ADJUST BRAKE
Your tractor is equipped with an adjust-
able brake system which is mounted on
the right side of the trensaxle.
If tractor requires more than six (6) feet
stopping distance at high speed in
highest gear, then brake must be ad-
justed.
• Depress clutcWbreke pedal and
engage parking brake.
• Measure distance between brake
operating arm and nut =A" on brake rod.
• If distance is other than 1-112", loosen
jam nut and tum nut "A" until distance
becomes 1-I/2". Retighten jam nut
against nut =A".
• Road test tractor for proper stopping
distance as stated above. Readjust if
necessary. If stopping distance is still
greater than six (6) feet in highest gear,
further maintenance is necessary.
Contact your nearest authorized
service centerldepartment.
With Parking Brake
"Engaged"
Nut "A"
/ Jer .at
_OperaUng Arm " .
TO REPLACE MOTION DRIVE BELT
Park the tractor on level surface. Engage
parking brake. For assistance, there is a
belt installation guide decal on bottom
side of left footrest.
• Remove mower (See ='I'O REMOVE
MOWER" in this section of this manual.)
• Remove bolt from stationary idler and
clutching idler.
• Pull bolt slack toward rear of tractor.
Remove bolt upwards from transaxle
pulley by deflecting bolt keepers.
• Pull belt toward front of tractor and
remove downwards from around
engine pulley.
• Install new belt by reversing above
procedure.
Engine
Pulley
Clutching
Idler t
Stationary 7
Idler
i
0
TRANSAXLE GEAR SHIFT LEVER
ADJUSTMENT
The transaxle should be in neutral when
the gear shift lever is in neutral (N) (lock
gate) position. The adjustment is preset at
the factory; however, if adjustment is
needed, proceed as follows:
• Make sure transaxle is in neutral (N).
NOTE: When the tractor rear wheels
move freely, the transaxle is in neutral.
• Loosen adjustment bolt in front of the
right rear wheel.
• Position the gear shift lever in the
neutral (N) position.
• Tighten adjustment bolt securely.
NOTE: If additional clearance is needed
• to get to adjustment bolt, move mower
deck height to the lowest position.
23