Mb Intelligent Tweaker(M.i.t.) - Gigabyte GA-MA78GM-DS2HP User Manual

2-3

MB Intelligent Tweaker(M.I.T.)

HT Link Frequency
VGA Core Clock control
x VGA Core Clock (Mhz)
CPU Clock Ratio
CPU NorthBridge Freq.
CPU Host Clock Control
x CPU Frequency (MHz)
PCIE Clock (MHz)
Set Memory Clock
x Memory Clock
DCTs Mode (Note)
******** System Voltage Optimized
System Voltage Control
x DDR2 Voltage Control
x NorthBridge Volt Control
x SouthBridge Volt Control
x CPU NB VID Control
x CPU Voltage Control
Normal CPU Vcore
: Move
Enter: Select
F5: Previous Values
• Whether the system will work stably with the overclock/overvoltage settings you made is
dependent on your overall system configurations. Incorrectly doing overclock/overvoltage
may result in damage to CPU, chipset, or memory and reduce the useful life of these
components. This page is for advanced users only and we recommend you not to alter the
default settings to prevent system instability or other unexpected results. (Inadequately alter
ing the settings may result in system's failure to boot. If this occurs, clear the CMOS values
and reset the board to default values.)
• When the System Voltage Optimized item blinks in red, it is recommended that you set
the System Voltage Control item to Auto to optimize the system voltage settings.
HT Link Frequency
Allows you to manually set the frequency for the HT Link between the CPU and chipset.
Auto
200 MHz~2.6 GHz Sets HT Link Frequency to 200 MHz~2.6 GHz.
VGA Core Clock control
Enables or disables the control of VGA Core clock.
VGA Core Clock (Mhz)
Allows you to manually set the VGA Core clock. The adjustable range is from 200 MHz to 2000 MHz.
This item is configurable only if the VGA Core Clock control option is enabled. (Default: 500)
CPU Clock Ratio
Allows you to alter the clock ratio for the installed CPU. The adjustable range is dependent on the
CPU being used.
CPU NorthBridge Freq.
Allows you to alter the North Bridge controller frequency for the installed CPU. The adjustable
range is dependent on the CPU being used.
(Note) This item is present only if you install a CPU that supports this feature.
CMOS Setup Utility-Copyright (C) 1984-2008 Award Software
MB Intelligent Tweaker(M.I.T.)
(Note)
********
(Note)
+/-/PU/PD: Value
F6: Fail-Safe Defaults
BIOS will automatically adjust the HT Link Frequency. (Default)
(Note)
[Auto]
[Disabled]
500
[Auto]
[Auto]
[Auto]
200
[Auto]
[Auto]
DDR 533
[Unganged]
[Auto]
Normal
Normal
Normal
Normal
Normal
1.1000V
F10: Save
- 41 -
Item Help
Menu Level
ESC: Exit F1: General Help
F7: Optimized Defaults
BIOS Setup