Gigabyte GA-MA78G-DS3H User Manual page 83

B. Installing Windows Vista
(Note)
(The procedure below assumes that only one RAID array exists in your system.)
Step 1:
Restart your system to boot from the Windows Vista setup disk and perform standard OS installation
steps. When a screen similar to that below appears (RAID hard drive will not be detected at this stage),
select Load Driver. (Figure 6).
Figure 6
Step 2:
Specify the location where the driver is saved, such as your floppy disk, browse the LH(for Vista 32bit)
or LH64A(for Vista 64 bit) folder. (Figure 7).
Figure 7
(Note) For AHCI drives, installation of Windows Vista does not require you to install the SATA AHCI
driver in advance during the OS installation process.
- 83 - Appendix