Gigabyte GA-MA780G-UD3H User Manual page 46

PEG
PEG1
AMD C1E Support
Enables or disables the C1E CPU power-saving function in system halt state. When set to
Software SMI, the CPU core frequency and voltage will be reduced during system halt state to
decrease power consumption. (Default: Software SMI)
Virtualization
Virtualization allows a platform to run multiple operating systems and applications in independent
partitions. With virtualization, one computer system can function as multiple virtual systems.
(Default: Disabled)
Patch AMD TLB Erratum
Enables or disables the Patch AMD TLB Erratum function. (Default: Enabled)
AMD K8 Cool&Quiet control
Auto
Disabled
Hard Disk Boot Priority
Specifies the sequence of loading the operating system from the installed hard drives. Use the up
or down arrow key to select a hard drive, then press the plus key <+> (or <PageUp>) or the minus
key <-> (or <PageDown>) to move it up or down on the list. Press <Esc> to exit this menu when
finished.
First/Second/Third Boot Device
Specifies the boot order from the available devices. Use the up or down arrow key to select a
device and press <Enter> to accept. Options are: Floppy, LS120, Hard Disk, CDROM, ZIP,
USB-FDD, USB-ZIP, USB-CDROM, USB-HDD, Legacy LAN, Disabled.
Password Check
Specifies whether a password is required every time the system boots, or only when you enter
BIOS Setup. After configuring this item, set the password(s) under the Set Supervisor/User
Password item in the BIOS Main Menu.
Setup
System
HDD S.M.A.R.T. Capability
Enables or disables the S.M.A.R.T. (Self Monitoring and Reporting Technology) capability of your
hard drive. This feature allows your system to report read/write errors of the hard drive and to
issue warnings when a third party hardware monitor utility is installed. (Default: Disabled)
Away Mode
Enables or disables Away Mode in Windows XP Media Center operating system. Away Mode
allows the system to silently perform unattended tasks while in a low-power mode that appears off
(Default: Disabled)
Full Screen LOGO Show
Allows you to determine whether to display the GIGABYTE Logo at system startup. Disabled
displays normal POST message. (Default: Enabled)
(Note) This item is present only if you install a CPU that supports this feature.
GA-MA780G-UD3H Motherboard
Sets the PCI Express graphics card on the PCIEX16_1 slot as the first display.
Sets the PCI Express graphics card on the PCIEX4_1 slot as the first display.
(Note)
Lets the AMD Cool'n'Quiet driver dynamically adjust the CPU clock and VID to
reduce heat output from your computer and its power consumption. (Default)
Disable this function.
A password is only required for entering the BIOS Setup program. (Default)
A password is required for booting the system and for entering the BIOS Setup
program.
- 46 -