Electric Brake - Craftsman nextec 320.10004 Operator's Manual

TRIGGER SWITCH (Fig. 4)
To turn the saw ON, depress
the lock-off button and then
depress the trigger switch.
To turn it OFF, release the
trigger switch and the lock-off
button will automatically locked.
NOTE: The lock-off button can
be activated when the trigger
is released.
,_ WARNING: Battery
tools are always in operating
condition. Therefore, the trigger
switch should always be locked
when not in use or when
carrying the tool at your side.
ELECTRIC BRAKE
To stopthe Multi-Saw,release
the triggerswitchand allow the
toolto cometo a completestop.
The electdcbrake quicklystops
the saw blade.Thisfeature
engagesautomatically when
you releasethetriggerswitch.
Fig. 4
_/_' Trigger
\ Lock-O.
' L__
:.:,' Button
t J
above the tool-less blade clamp, provides additional lighting on the surface of
the workpiece for operation in lower-light areas. The LED work will come on
when the trigger switch is depressed. The LED worklight will turn off when the
trigger switch is released.
INSTALLING SAW
BLADE (Fig. 6, Fig. 6a)
1. Remove the battery pack.
2. Turn the tool upside down,
and insert the blade into the
slot of the tool-less blade
clamp until it locks into
place. The blade must rest
in the groove of the guide
roller as indicated in Fig. 8.
To Slide Steel Base In or Out:
(See Fig.6b)
The steel base slides in or out to
accommodate various
blade widths.
1. Remove the battery.
2. Loosen the Hexagon
Socket Screw
3. Pull the steel base to
desired position (the base
moves a maximum of 1/4
inch forward or backward).
4. Tighten the Hexagon
Socket Screw.
er
Fig. 6a _/
__ide Roller
F000 /--7
Hexagon socket screw / \ /]
10004 ManuaLRevised_08-0813 Page 16 10004 Manual Revised_08-0813 Page 17