Table of Contents
Advertisement
TROUBLESHOOTING CHART:
See appropriate
section in manual unless directed to Sears service center
PROBLEM
LOSSof power
Excessive
vibration
Enginecontinues
torun
when operator
leaves seat with
with attachment
clutch engaged
CAUSE
CORRECTION
Poor cut - uneven
1. Cutting too much grass/too
fast.
2. Throttle
in "CHOKE"
position.
3. Build-up of grass, leaves
3.
and trash under mower.
4. Dirty air filter.
4.
5. Low oil level/dirty oil.
5.
6. Faulty spark plug.
6.
7. Dirty fuel filter.
7.
8. Stale or dirty fuel.
8.
9. Water in fuel.
9.
10.Spark plug wire loose.
11.Dirty engine air screen/fins.
12. Dirty/clogged muffler.
13. Loose or damaged wiring.
14.Carburetor
out of
adjustment.
15. Engine valves out of
adjustment.
_1. Worn, bent or loose blade.
1.
2. Bent blade mandrel.
2.
3. Loose/damaged
part(s).
3.
1. Faulty operator-safety
1.
presence control system.
1. Wom, bent or loose blade.
1.
2. Mower deck not level.
2.
3. Buildup of grass, leaves,
3.
and trash under mower.
4. Bent blade mandrel.
4.
5. Clogged mower deck vent
5.
holes from buildup of
grass, leaves, and trash
around mandrels.
1. Set in "Higher Cut" position/
reduce speed.
2. Adjust throttle control.
Clean underside of mower
housing.
Clean/replace
air filter.
Check oil leveVchange oil.
Clean and regap or change
spark plug.
Replace fuel filter.
Drain fuel tank and refill with
fresh gasoline.
Drain fuel tank and carbure
tor, refill tank with fresh
gasoline and replace fuel
filter.
10. Connect and tighten spark
plug wire.
11. Clean engine air screen/fins.
12. Clean/replace
muffler.
13.Check all wiring.
14. See _lo Adjust Carburetor"
in Service Adjustments
section.
15.Contact a Sears or other
qualified service center.
Replace blade.
Tighten blade bolt.
Replace blade mandrel.
Tighten loose part(s).
Replace damaged pads.
Check wiring, switches and
connections. If not
contact a Sears or other
qualified service center.
Replace blade. _ghten
blade bolt.
Level mower deck.
Clean underside of mower
housing.
Replace blade mandrel.
Clean around mandrels to
open vent holes.
31
Advertisement
Table of Contents
