Path Settings - X10 AIRSIGHT XX34A User Manual

3.20 Path Settings


Figure 10.8
Here you can set record path and alarm record path for the camera
Record Path: Here you can set the manually record path. Click
record file will be saved to the specified path you set here.
Alarm Record Path: Here you can set the alarm record path. When motion is detected, and record enabled, it
will start alarm record automatically, the record file will be saved to the specified path you set here .
NOTE: If you couldn't set the path here in Windows 7 or Vista, please do it as below:
Windows 7 or Vista's security level is higher than Windows XP, for "Path Settings"
1. User could add the Device IP address to the IE's 'Trusted sites' first. The step is:
"IE browser→Tool→Internet Proper→Security→Trusted sites→Sites→Add".
2. You can also run the IE as administrator, input the IP address of the camera manually. (Figure 11.1).
.
Figure 10.9
Figure 11.0
Figure 11.1
51
then start manual recording, the