Advertisement
To set whether you want the MS13A to transmit EVERY time it sees motion or only at night:
Press the Unit/Off button once. The red LED flashes. Then press and hold the House/On button. The green
LED turns on. 3 seconds later the MS13A reports its dusk/dawn setting as follows:
The red LED blinks once if the MS13A is set to detect motion at all times.
The red LED blinks twice if the MS13A is set to detect motion only when it's dark.
To change this, Press the Unit/Off button once. The red LED flashes. Then press and hold the House/On
button. The green LED turns on. 3 seconds later the MS13A reports its dusk/dawn setting. Release and immedi-
ately press the House/On button once for operation at all times, or twice for operation only at night.
Hold the button for 3 seconds on your last press. The red LED then reports the setting with one or two blinks.
To change the delay after motion is detected before an OFF code is transmitted:
Press the House/On button once. The red LED flashes. Press and hold the Unit/Off button. The green LED
turns on. 3 seconds later the red LED reports its delay setting as follows:
1 blink for 1 minute.
2 blinks for 2 minutes.
3 blinks for 4 minutes.
4 blinks for 8 minutes.
5 blinks for 16 minutes.
6 blinks for 32 minutes.
7 blinks for 64 minutes.
8 blinks for 128 minutes.
9 blinks for 256 minutes.
To change this, Press the House/On button once. The red LED flashes. Press and hold the Unit/Off button. The
green LED turns on. 3 seconds later the red LED reports its delay setting. Release and immediately press the
Unit/Off button the number of times for the delay you want. Hold the button pressed for 3 seconds on the last
press. The red LED then reports the setting with the appropriate number of blinks as above. Release the button.
NOTES:
After replacing batteries, you need to wait 30 seconds before the MS13A will see any motion.
After a transmission, you need to wait 10 seconds before the MS13A will see you.
The default House and Unit Code transmitted when motion is detected is A 1-ON.
The default for motion detection is detect at all times (day and night).
The default time out after which (default) A 1-OFF is sent is 1 minute.
The default House and Unit Code transmitted when dusk/dawn is sensed is A 2-ON at dusk, A 2 -OFF at dawn.
F.C.C. CAUTION - THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS
SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL
INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUD-
ING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.
NOTE: NO CHANGES OR MODIFICATIONS MAY BE MADE TO THE UNITS. ANY CHANGES MADE
TO THE UNITS WILL VOID THE USER'S AUTHORITY TO OPERATE THE EQUIPMENT.
DR/MS13A-4/99
Advertisement
