Macintosh; Energy Star Compliance; Important Safety Instructions - Epson Stylus Photo 2000P Printer Basics Manual

Macintosh

To use your printer and its software, your system should have:
An Apple
®
Mac OS 8.5.1 or later
If your iMac is running OS 8.1, you'll need to upgrade your operating system before
connecting the printer to your computer. If your iMac is running OS 8.5.1, Apple
recommends that you install iMac Update 1.1, available on the Apple web site. To
find out which operating system your Macintosh is running, select About This
Computer from the Apple menu.
64MB of available RAM (128MB or more recommended)
200MB of free hard disk space recommended
CD-ROM or DVD drive for installing the printer software
A shielded USB "AB" cable up to 9.8 ft. (3 meters) long.
Using an improperly shielded USB cable—especially a cable more than 9.8 ft.
(3 meters) long—may cause the printer to malfunction.
E
NERGY
As an ENERGY STAR Partner, EPSON has determined that this
product meets the ENERGY STAR guidelines for energy efficiency.
The EPA ENERGY STAR office equipment program is a voluntary
partnership with the computer and office equipment industry to
promote the introduction of energy-efficient personal computers,
monitors, printers, fax machines, and copiers in an effort to reduce air
pollution caused by power generation.

Important Safety Instructions

Before using your printer, read the following safety instructions to make sure you use the printer safely
and effectively:
Be sure to follow all warnings and instructions marked on the printer.
Do not place the printer on an unstable surface or near a radiator or heating vent or in direct
sunlight.
Use only the type of power source indicated on the printer's label.
Connect all equipment to properly grounded power outlets. Avoid using outlets on the same
circuit as photocopiers or air control systems that regularly switch on and off.
62
® ™
iMac series Power Macintosh
S Compliance
TAR
®
G3 or G4 with USB port