Download Print this page

KitchenAid Dishwasher User Instructions page 4

Advertisement

Available languages

Available languages

Depending
onyour w ater h ardness,
filltheMain Wash s ection
ofthedispenser asshown. Fill t hePre-Wash section tothe
level s hown, ifneeded.
NOTE: Fillamounts shown
areforstandard powdered
detergent. Follow
instructions onthepackage
when using other
dishwasher
detergent.
Soft Water
HardWater
iVlain Wash
Pre-Wash
STEP 3
Select
a Cycle
(cycles
vary by model)
See "Cycle and Option Descriptions"
charts in the following
section.
Heavier cycles and options affect cycle length. Some cycles and
options will take up to 31/2hours to complete.
Add Rinse Aid
Your dishwasher is designed to use rinse aid for good drying
performance.
Without rinse aid your dishes and dishwasher
interior will have excessive moisture. The heat dry option will
not perform as well without rinse aid.
Rinse aid keeps water from forming droplets that can
dry as spots or streaks. They also improve drying by
allowing water to drain off of the dishes after the final
rinse.
Rinse aid helps to reduce excess moisture on the dish
racks and interior of your dishwasher.
Check the rinse aid indicator. Add rinse aid when indicator
drops to "Add" level.
Full
Add
To add rinse aid, turn the dispenser cap
Lock
to "Refill" and lift off. Pour rinse aid into
>>n
the opening until the indicator level is at
"Full." Replace the dispenser cap and
turn to "Lock." Make sure cap is fully
locked.
Refill
¼ turn to lock
NOTE: For most water conditions, the
factory setting of 2 will give good
results. If you have hard water or notice
rings or spots, try a higher setting. Turn
the arrow adjuster inside the dispenser
by either using your fingers or inserting
a flat-blade screwdriver into the center
of the arrow and turning.
Select
Options
(options
vary by model)
See "Cycle and Option Descriptions"
charts in the following
section.
You can customize your cycles by pressing the options desired.
STEP4
Start
or Resume
a Cycle
Run hot water at the sink nearest your dishwasher until the
water is hot. Turn off water.
Push door firmly closed. The door latches
automatically. Select the wash cycle and options
desired OR press START/RESUME to repeat the same
cycle and options as in the previous wash cycle.
You can add an item anytime before the main wash starts.
Open the door slowly and add the item. Close the door firmly.
Press START/RESUME.

Advertisement

loading