Zenith SRV1341 Operating Manual & Warranty page 11

CABLE WITHOUT CONVERTER/
DE-SCRA MBLER BOX
Use this connection if your cable system connects
directly to your TV/VCR without a converter box.
By using this connection you can:
1) Use the TV/VCR remote to select channels
2) Program one or more unscrambled channels for
Automatic Timer Recording.
From Cable System
75-ohm
Coaxial Cable
(not supplied)
ANT.(_
CABLE WITH
CONVERTER/DE-SCRAMBLER BOX
If your cable service supplies you with a converter box,
you can use the basic connection shown below.
By using this connection you can record and view any
channel including scrambled channels. However, chan-
nel selection must be made using the converter box. This
means that channels cannot be changed using the
TV/VCR Remote Control. Unattended recording is
limited to one channel at a time.
Box (not suppiled)
,From Cable System
75-ohm
TO RECORD A SCRAMBLED/UNSCRAMBLED
CHANNEL
1. Set the TV/VCR channel selector to the output
channel for the Cable Converter Box. (Ex. CH3)
2. Select which channel to record from your Cable
Converter Box.
NOTE: When using a cable converter box, you cannot
record one channel and view another.
Note to CATV system installer:
This reminder is provided to call the CATV system installer's attention to Article 820-40 of the NEC that
provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected
to the grounding system of the building as close to the point of cable entry as practical.
-11-
EN
6F06