Zenith ZW6500R Owner's Manual page 17

Operating Instructions
The controls look like this:
Controls
TemperatureSetting
• This button can automatically control the temperature
of the room. The temperature can be set within a range of
60 F to 86 F by1 F.
Select the lower number for lower temperature of the room.
EnergySaver
The fan stops when the compressor stops cooling.
• Approximately every 3 minutes the fan will turn on and
check the room air to determine if cooling is needed.
Fan/Cool/Dry
• Everytime you pushthis button, it will togglebetween
COOL, FAN, and DRY.
On/Off Timer
- Stopping Operation
Each press of the button cycles through the options in this
order: 1 Hour• 2 Hours • 3 Hours • 4 Hours. 5 Hours
• 6Hours, 7Hours• 8Hours• 9Hours• 10 Hours•
11 Hours, 12Hours° CANCLE.
The set temperature will be raised 2 F after 30 minutes
and again after another 30 minutes.
- Stopping Operation
Each press of the button cycles through the options in this
order: 1 Hour, 2 Hours ° 3 Hours • 4 Hours. 5 Hours
• 6Hours• 7Hours• 8Hours• 9Hours• 10 Hours•
11 Hours, 12Hours, CANCLE.
Fan Speed
]
• Pressing the Fan Speed button toggles between Low and |
High speeds.
L__
Power
1
• To turn the unit ON, push the button. To turn the unit OFF, |
push the button again.
[
• This button takes priority over any other buttons.
• When the unit is first powered up, it defaults to settings of
High Cool at 72 F.
Dry Fan
Cool
On
Off
1
@
%
Owner's Manual 17