Download Print this page

Troubleshooting - JVC RX-6000VBK Instructions Manual

Audio/video control receiver
Hide thumbs Also See for RX-6000VBK:

Advertisement

Troubleshooting
Use this chart to help you salve daily operational
problems,
ff there is any problem you cannot solve, contact your JVC
service center.
PROBLEM
POSSIBLE
CAUSE
The display does not light up.
The power cord is not plugged
in.
No sound from speakers.
Speaker
signal cables are not connected.
The SPEAKERS
1 and 2 bu|tons
are not
set correctly.
An incorrect source is selected.
Muting is activated.
Speaker
signal cables are not connected
properly.
The balance is set to one extreme.
Incoming
signal is too weak.
Sound fi'om one speaker only.
Continuous
hiss or buzzing during FM
reception.
Occasional
cracking noise during FM
reception.
ttowling
during record playing.
"OVERLOAD"
starls llashing on the
display.
Remote con|rol does not work.
The station is too 13r away.
An incorrect antenna is used.
SOLUTION
Plug the power cord into an AC outlet.
Check speaker wiring and reconnect
if
necessary.
Press SPEAKERS
1 and 2 correctly.
Select the correct source.
Press MUTING
to cancel the mute.
Check speaker wiring and reconnect
if
necessary.
Artiust the balance
properly (see page 11).
Connect
an outdoor FM antenna or contact
your dealer.
Select a new station.
Check with your dealer to be sure you have
the
correct
antenna.
Antennas
are not connected properly.
Check connections.
Ignition noise from automobiles.
Move the antenna li_rther from automobile
traffic.
Your turntable is too close to speakers.
Move speakers
away from the turntable.
Speakers
are overloaded
because
of high
volume.
Speakers
are overloaded
because
of short
circuit of speaker terminals.
There
is an obstruction
in front
of the
remote
sensor
on the receiver.
1. Press POWER on the front panel to turn off
the receiver.
2. Stop the playback
source.
3. Turn on the receiver again, and adjust the
volume.
Press POWER on the l?ont panel to turn off
the receiver, check the speaker wiring, then
press it again to turn on llle receiver
again.
If "OVERLOAD"
does not disappear
though
speaker wiring is not shod-circuited,
consult
your dealer.
Remove
the obstruction.
Batteries are weak.
Replace
batteries.
!
31

Advertisement

loading

This manual is also suitable for:

Rx-6008vbk