Parallel Recordings - Technics RS-TR575 Operating Instructions Manual

The same sound source can be recorded simultaneously to both
Deck 1 and Deck 2.
64 135 2 14 6
I I
6 6
.... F_'_C;.;'V;"- .... Begin piayback of the Sound
source, and then use the
0_)10 REC LEVEL control to ad-
Just the recording level.
After that, atop the play being done so as to ad-
Just the recording level.
_ i_;ck 1 ; . ...... P 'r.._, :_ori_o,; 6.c"1=,d
_--]_-_ Deck 2 at the same time,
_-i:_x-_ and play the source to be
'L--:_-J recorded.
(Deck 2) •: Forward side
41: Reverse side
JW
[ Preparation ]
• Wind the tape past the leader tape section so that recording
can begin straight away.
• Set the BALANCE control to the center position.
decks, and then Insert the
_._"_ cassette tapes to be used
for recording.
Press again to close the cassette
holder.
the desired noise-reduction
system.
• The same direction of tape movement for recording should be
selected for each tape deck.
• When recording on both sides of the tape, be sure to press the
• buttons.
To temporarily stop recording
PAUSE
Press II
PAUSE on both decks.
Press once again to resume recording.
To stop recording
Press • on both decks.
I r,,mm
.... R_-VERS;- ..... PressREVERsEMODEso MOOE J,i _ ,, I;t, ,, •
that the ._ or _ m-
_ dicator Illuminates.
"_ _ : Only one side will be recorded.
(:_: Both sides of the tape will be
recorded.
To record using the ATC function, now press the
ATC button on Deck 1, and then, after the ATC set-
tings have been completed, press the ATC button
on Deck 2.
Different sound sources cannot be recorded separately on deck
1 and deck 2 at the same time.
Deck 2.
Both decks will then change to the
___ recording stand-by mode.
16