The Printer Does Not Start Printing - Samsung SRP-275 User Manual

• Errors that are impossible to recover
Error
R/W error in memory
or gate array
High voltage error
Low voltage error
CPU execution error
Print head temperature
detection circuit error.
NOTES
If you see this light blinking, turn off the printer for a few seconds and then turn it back on.
If the light is still blinking, call your supervisor or a service person.

11-2 The printer does not start printing

• Are any of the operation panel lights on, If no operation panel lights are on, check the following:
- Make sure that the printer is turned on.
- Make sure that the power supply cable is correctly plugged into the printer and to the power outlet.
• If any of the lights are on, please check the following:
- If the POWER LED is blinking, the printer is not ready yet.
Wait until the light quits blinking and the printer is ready to use.
- If the ERROR LED is on (but not blinking), the printer is off line. Check to see that the covers are closed
and check the paper state. See Chapter 5 for instructions on installing or replacing the paper roll.
- If the ERROR LED is blinking, there is an error. In this case, turn off the printer for a few seconds and
then turn it back on. If the light is still blinking, call your supervisor or service person.
- If the PAPER OUT LED is on, check the paper roll in the printer. See Chapter 5 for instruction on
installing the paper roll.
Rev. 1.03
Description
After R/W checking, the
printer does not work
correctly.
Writing to, reading out, or
erasing the NV memory for
image scanning results
does not work correctly.
The power supply voltage
is extremely high.
The power supply voltage
is extremely low.
The CPU executes an
incorrect address or I/F
board is not connected.
There is an abnormality is
the print head temperature.
ERROR LED blinking pattern
200ms
- 38 -
SRP-275
Recovery
Recovers automatically
when the rear cover is
closed.
Impossible to recover.
Impossible to recover.
Impossible to recover.
Impossible to recover.