How To Enter Into The Engineering Mode - Vision Fitness T970HRT Service Manual

T9700(TM51D/E) TREADMILLS (for Software Ver. 2.5)
Apply to :
1. VISION T9700/T9600 serise treadmail .
2. 2004 year T9700 serise treadmail.
3. 2004 year for ID

How to enter into the engineering mode?

Display show
CONFIGURE
DISPLAY TEST
BURN IN TEST
AUTO CAL
SPEED SENSOR
RS 232 TEST
HR TEST
1. Press & Hold both "ELEVATION UP"
and "SPEED DOWN" at the same time for
3-5 sec. Then, the dot vision display will
show "DGB1J
show VERSION "
2. Press the "ELEVATION" or "SPEED" to
selectyou want and press the "SELECT"
key enter.
function interpret
set the treadmill all parameter
console LED test mode
treadmill running test mode
Auto-calibration mode
speed sensor test mode
RS-232 test mode
HR test mode
3-1
A564" and right display is