Chapter 8 - Command Tables; Operation; Vertical Positioning - Bematech MP-2100 TH User Manual

Chapter 6
Command T Command T ables ables
Command T Command Tables Command T ables ables

Operation

ASCII Dec
ESC @ 64
ESC b n 98
ESC v n 118
ESC w 119
ESC x 120
ESC y n 121
ESC z 1/0 122
ESC m 109

Vertical Positioning

ASCII Dec
ESC C n 67
ESC c n1 n2 99
ESC J n 74
FF 12
LF 10
ESC 2 50
ESC 3 n 51
ESC f 1 n 102
ESC A n 65
18
Hex Description
40 Initializes the printer
62 Enable (1): Status drawer sensor
Disable (0): Status paper sensor
76 Activate drawer (n miliseconds)
-50ms < n < 200ms
77 Performs a paper cut
78 Enable Dump Mode
79 Enable (1) or Disable (0). Keyboard default (1)
7A Enable automatic line feed (n=1). Disable automatic line feeed (n=0)
6D Performs a parcial paper cut
Hex Description
43 Programs the page size in lines where n is the number of lines
(single height). The standard is 12 lines (of single height).
63 Programs the page size in millimeters where Size=0,125mm*n1*n2.
4A Performs the feeding of n*0,125mm of paper.
0C Feeds one page.
0A Feeds one line.
32 Line feed of 1/6" – default line feed
33 Line feed of n/144 of an inch, where n goes from 18(d) up to 255(d).
66 Vertical skipping of n characters.
41 Performs the feeding of n*0,375mm of paper.
User's Manual