When connecting Customer Display
This section explains how to install the APD when connecting a Customer Display to a TM
printer. For the APD of version 4.07 or later, the printer drivers for both 32 bit and 64 bit version
OS are installed.
Installation Flow
1.
Installation when using pass-through connection (page 32)
Installation when using Y-connection (page 36)
Installation when using pass-through connection
The pass‐through connection is a connection method to connect the computer and the TM
printer via the Customer Display.
The serial interface must be used and the communication settings on each of the three devices
must be the same. For information on DIP switch / Memory switch settings on the Customer
Display and the TM printer, see the Userʹs Manual supplied with the TM printer or the Technical
Reference Guide.
32
2.
Connecting the devices (page 40)
3.
Test print/display (page 41)
Serial
Serial
to TM printer
Modular