Table of Contents
Advertisement
Now, run the program by typing RUN and pressing
print your file or document by following the printing instructions of
your software. The LX-90 will print your example in standard single-
strike printing, as shown below:
Now that you have created a sample, follow these steps to print it in
emphasized mode:
1. See that both the ON LINE and READY lights are on.
2. Press the ON LINE and FF buttons at the same time. You hear a
beep to signal that SelecType is on.
3. As shown in Table 2-1, the code for emphasized is two. Therefore,
press the ON LINE button two times. (Remember to make sure
you hear a beep each time you press the ON LINE button when
you are in SelecType mode.)
4. Now that you have
button once to set it.
5. Push the LF button once to return the panel to its standard opera-
tion.
6. Press the ON LINE button so the LX-90 is ready to print.
Now you have set the LX-90 to print in emphasized mode. Print
your sample once more. It should appear in emphasized mode just as
you see below:
Turn off your printer to cancel the emphasized setting, and-if you
wish-try this exercise with other modes. If you are using commercial
software and SelecType will not change the typestyle, see "SelecType
Features" in Appendix E.
12
T h i s i s a n e x a m p l e o f
L X - 9 0 p r i n t i n g .
the emphasized mode, push the FF
selected
an
This is
LX-90
printing.
example
of
or
RETURN,
Advertisement
Table of Contents
