Adjusting The Tear-Off Position - Epson LQ-570 User Manual

Tear Off

Adjusting the tear-off position

If the perforation is not aligned with the tear-off edge, adjust the
tear-off position by following the steps below:
Make sure the paper is in the tear-off position and the TEAR OFF
1.
light is on.
2. While holding down the ALT button, press the LOAD/EJECT
button to adjust the tear-off position to a lower position on the
page or press the LF/FF button to adjust the tear-off position to a
higher position on the page. The printer remembers the new
tear-off position.
3. Tear off any printed pages.
When you begin printing, the printer automatically feeds the
4.
paper back to the loading position and begins printing. (You c a n
also manually feed the paper back to the loading position by
pressing the LOAD/EJECT or TEAR OFF button.)
Note:
The printer has a minimum and maximum tear-off position. If
l
you try to advance the loading position beyond these limits,
the printer beeps and the paper stops moving.
When the paper reaches the factory-set tear-off position, the
l
printer beeps and paper feeding pauses briefly. Use the factory
setting as a reference point when adjusting the tear-off
position.
3-18 Using the Printer