ANNOUNCE ONLY FEATURE
The '
' feature plays a prerecorded outgoing message, "Hello, no one is
Announce Only
available to take your call. Please call again," but it will not allow the caller to leave a message.
SETTING THE MESSAGE ALERT TONE
The Message Alert feature lets you know that you have new messages by sounding a short
beeping tone. If the Message Alert has been set to '
the alert tone will sound every 15 seconds. Set the Message Alert tone to '
using the
following procedure:
1. Press
five times. '
Message Alert
menu
([
] Off or [
] On), and it is displayed on the base.
OF
On
2. Press
or
to select.
3. Press
to select the new setting, a confirmation tone sounds, then the
set
announcement '
' and the current setting you have selected is
Message Alert
announced. When the first new message is received, the beeping tone will begin to
sound.
4. Press
/stop to exit menu options.
To quickly turn '
' tone off, press any key on the base unit and the
Message Alert
l
tone will automatically deactivate. To reset, go back into the menu setup mode.
When all new messages are played using the remote playback feature (page 28) the
l
'
' tone will automatically deactivate.
Message Alert
' and a new message has been received,
On
' or '
' by
On
Off
' is announced and the current setting
Page 22
memo
ans vol.
greeting
delete
play/stop
speaker
in use
charge
rep/rew
skip/ff
ans on/off
menu
set/ring