Advertisement
To Assemble Your
™
Entertainer
Activity Center
Step 1.
Turn the tray over and
locate the hole that the
seat lock screws into. Place
the seat lock on the tray as
shown and screw it to the
tray. DO NOT overtighten
screw—seat lock must be
free to slide.
Step 2.
Four tabs are located
behind the indentations
inside the seat ring.
Remove the seat ring by
pulling the four tabs out
from under the tray, one
at a time, while lifting the
seat ring.
Step 3.
Put the seat ring upside
down inside the cloth seat.
The high side of the seat
ring goes to the back of the
seat, where the warning
label is located.
Attach the seat to the seat
ring by tucking the seat
edge into the channel and
snapping the grommets on
the pegs.
Step 4.
Turn the seat over and
push the seat down into the
seat ring.
Step 5.
Snap the seat ring back
onto the tray. Make sure all
four tabs are snapped onto
the inside lip.
291-12-97
Solid color inside
Grommet
Pattern side
Pattern side UP
5
Step 6.
Turn tray over. Push one leg into socket in tray exactly as
shown until it snaps into place. Repeat for other two legs.
Button
faces seat
RIGHT
Step 7.
On top of tray, CHECK that
snaps are visible through
slots. Pull on leg to be sure it
is securely attached.
Step 8.
Slide the leg tubes on the tray onto the leg tubes on the
base as shown.
HINT: If a tray leg tube will not slide onto the base leg tube,
twist the base tube slightly to line up the parts.
Push in the buttons on each of the upper leg tubes and
adjust the activity center to the desired height.
The bottom edge of the upper tubes must be even with one
of the three lines on the lower leg tube.
CHECK that all three leg tubes are set to the same
height.
WRONG
Snaps visible
Buttons
Line
6
Advertisement
