How To Use New Features; Displaying The Fabric While Aligning The Embroidery Position - Brother Quattro 6000D Operation Manual

HOW TO USE NEW FEATURES

Displaying the Fabric While Aligning
the Embroidery Position
The fabric hooped in the embroidery frame can be
displayed on the LCD so that the embroidery position
can be aligned.
This feature can be used from the sewing screen of
embroidery mode and the edit and sewing screens of
embroidery edit mode.
As an example, the following procedure is described
using the edit screen of the embroidery edit mode.
Note
• When embroidery frame (small: H 2 cm × W 6 cm (H
1 inch × W 2-1/2 inches)) is installed, the built-in
camera cannot be used to align the embroidering
position. Install medium embroidery frame or larger.
• For details on using thicker fabric such as quilting,
refer to "Positioning the pattern on thick fabric"
(page 22).
a
Hoop the fabric in the embroidery frame, and
then attach the frame to the embroidery
machine.
b
Select the pattern, and then press
Note
• Check page 8/8 of Settings screen to make sure the
Fabric Thickness Sensor is turned off when using
light to medium weight fabrics.
20
c
Press
d
When the following message appears, press
.
.
→ The embroidery frame moves so the fabric can be
scanned.
Memo
• If you do not wish the upper thread to be scanned
together with the fabric, scan the fabric without the
needle threaded with the upper thread.
.