Unpaeking; Hooking Up The System - Sony CDP-CX455 Operating Instructions Manual

Unpacking
Check that you received the following items:
• Audio cord (1)
• Monaural
(2P) nfini-plug cord (1) (Connecting cord
for CONTROL AIII) (supplied tbr Canadian i-nodels
only)
• Remote COlnmander
(relnote) (l)
• Size AA (LR6) batteries (2)
Inserting batteries into the remote
You can control tile player using tile supplied remote.
Insert two size AA (LR6) batteries (supplied) by
matching the + and ends on the batteries to the
diagram inside the batte W compartment.
Insert the negative ( ) end first, then push in and down
until the positive (+) end clicks into position.
When using the remote, point it at the remote sensor []
on tile player.
"_ When to replace batteries
With normal use, the batteries should last for about six
montbs. When the remote no longer operates the player,
replace all the batteries with new ones.
Notes
• Do not leave the remote near an extremely hot or humid
place.
• Do not drop any foreign object into the remote casing,
particularly when replacing the batteries.
• Do not expose the remote sensor to direct sunlight or leave
too near lighting apparatuses. Doing so may cause a
malffmction.
• If you do not use the remote fioran extended period of time,
remove the batteries to avoid possible damage fi'om battery
leakage and corrosion.
Hooking Up the System
Overview
This section describes how to hook up the CD player to
an amplifier. Be sure to turn off the power of each
component befi)re making the connections.
CONTROL AIII
DIGITAL OUT
(OPTICAL)
CD player
To an AC outlet _
To Analog To Analog
output (L) output (R)
To audio input_ _ Amplifier
: Signal flow To an AC outlet
What cords will I need?
Audio cord (supplied) (1)
White
(L) _ "'5
Red
(R)
White
(L) Red
(R)
6 L/S