Table of Contents
Advertisement
Possible Causes and Remedies
Symptom
Remote control doesn't
work
To operate
your components,
make sure you've programmed
the remote
properly.
See "Programming
the Remote"
on page 79. Note: The remote
codes may be erased
whenever
you remove the batteries.
Program
the
remote again if you've
removed
or replaced
the batteries.
Press the appropriate
FUNCTION
button
for the component
you want to
operate.
E_i Check to make sure the batteries
are inserted
correctly, and that the batteries
are not dead. See page 7.
k.i
RF problems:
Check that the RF antenna
is connected
properly
and that
you're using the remote control within operating
range of the DSS receiver
(see "Setting Up the RF Antenna"
on page 22). Make sure that RF
transmission
is enabled
(see "Selecting
IR/RF Transmission"
on page 69).
Make sure the DSS receiver and remote control are using the same security
code (see"Setting
the Security
Code" on page 70).
If you are unable to resolve problems
with your system, please see
"Customer
Support"
on page 2 for customer
support
information
and
telephone
numbers.
Appendix:
Other Information
85
Advertisement
Table of Contents
