Sony DSS SAT-A1 Operating Instructions Manual page 70

_etting the :_ecurity CoUe
I tl_' L)_b3 Itt(ltJt_t _t_2_[ Yt'lliOlt' toillFol
are shipped with the RF security code
set to 000.
1t the D55 rc_civcl is uc_cpting ol receiving signals from anotheJ" RF
remote control in your home (or from a neighbor's house), you can
eliminate this problem by changing the security codes for the DSS
receiver and remote control.
Note
As an alternative, you can eliminate this problem by disabling the RF
capability of the DSS receiver, if you have no need for RF transmission. See
"Selecting IR/RF Transmission" on page 69for details.
There are two steps to changing the RF security code: Step 1 is
changing the DSS receiver's security code; step 2 is changing the DSS
remote control's security code. Both the receiver and the remote control
must use the same three-digit security code.
Step 1' Select the DSS Receiver's RF Security Code
1
Select SET UP REMOTE from the Installation Menu.
2 Select RF SECURITY CODE.
SET UP REMOTE
REMOTE SIGNAL RFONLY
000
3
[,_
4
5
m
Select a different security code and then select OK.
SET RF SECURITY CODE
CODE000 CODE001
CODE004 CODE005
CODE008 CODE009
CODE012 CODE013
II CODE002 ]ICODE003
][CODE 006 JlCODE 007
Jl[ CODE010 IIcODE 011
IICODE014 II CODE015
Select OK from the Set Up Remote screen to save your changes and
return to the Installation Menu.
Go to "Step 2: Set the DSS Remote Control's RF Security Code" on
page 71 to continue.
10 Chapter 6: Using the Installation Menu