Sony STR-DG510 Operating Instructions Manual page 66

Tuner
The FM reception is poor.
• Use a 75-ohm coaxial cable (not supplied)
to connect the receiver to an outdoor FM
antenna (aerial) as shown below. If you
connect the receiver to an outdoor antenna
(aerial), ground it against lightning. To
prevent a gas explosion, do not connect the
ground wire to a gas pipe.
Outdoor FM antenna (aerial)
_ Receiver
Ground wire
(not supplied)
¢
To ground
Radio stations cannot be tuned in.
• Check that the antennas
(aerials) are
connected securely. Adjust the antennas
(aerials) and connect an external antenna
(aerial), if necessary.
• The signal strength of the stations is too
weak (when tuning in with automatic
tuning). Use direct tuning.
• Make sure you set the tuning interval
correctly (when tuning in AM stations
with direct tuning).
• No stations have been preset or the preset
stations have been cleared (when tuning by
scanning preset stations). Preset the
stations (page 54).
• Press DISPLAY repeatedly on the receiver
so that the frequency appears on the
display.
RDS does not work.*
• Make sure that you are tuned to an FM
RDS station.
• Select a stronger FM station.
The RDS information that you want
does not appear.*
• Contact tile radio station and find out
whether they actually provide the service
in question. If so, the service may be
temporarily Ol.ltof order.
_-Models of area code CEL, CEK only.
Remote commander
The remote does not function.
• Point the remote at tile remote sensor on
the receiver.
• Remove any obstacles in the path between
the remote and the receiver.
• Replace all the batteries in the remote with
new ones, if they are weak.
• Make sure yon select the correct input on
the remote.
• The VIDEO 3 button on the remote is not
available for receiver operation.
Error messages
If there is a malfimction, the display shows a
message. You can check the condition of the
system by the message. Refer to the following
table to solve the problem. If any problem
persists, consult your nearest Sony dealer.
If an error message appears while you perform
Auto Calibration, see "Error and warning
codes" (page 30) to solve the problem.
DEC. EROR
Appears when u signal tile receiver cannot
decode (ex. DTS-CD) is input and "DEC.
PRI." on the AUDIO menu is set to "DEC.
PCM". Set it to "DEC. AUTO" (page 38).
66G8