Table of Contents
Advertisement
Connecting
Two RF
Inputs
If you want to watch RF signals for both antenna
(over-the-air)
and
cable broadcast
signals, you'll need to use an optional
A-B switch for
RF inputs (not supplied),
as shown below.
!V
* ,_¢
VHF/UHF
Use the A-B selector to switch between
the over-the-air
signals and
the cable signals. Then set the
setting in the Channel
Settings to
or
as described
on page 40.
Cable
Box Only
Your cable company
scrambles
all channels, which requires
you
to use a cable box.
You do not have a VCR. (If you have a VCR, see pages 8 and 9.)
Use the TV remote control to change channels
coming through
the cable box to the TV's VHF/UHF
jack. (You must first
program
the remote control for your specific cable box.)
_l
Connect the CATV cable to the cable box's input jack.
Use a coaxial cable to connect the cable box's output jack to the
TV's VHF/UHF
jack.
C_:W
Co;x;,
c,,5;
VHF/UHF
;,
{%
#
;
/__'_,.> _ ,_L/_i_ _/_/ ......._./_
Run Auto Program,
as described
in "Setting Up the Channel List"
on page 20.
Use the cable box
Tune
the TV to the channel
the cable box is set to (usually
channel
3 or 4)
and then
use the cable box to switch
channels.
Set up the TV remote
control
Program
the remote
control.
See "Programming
the Remote
Control"
on
to operate
the cable box
page
24.
Activate
the remote
controlto
Press
S_i i;i;
!
operate the cable box
Advertisement
Table of Contents
