Locating A Track - Sony MDS-B6P Operation Manual

MULTI ACCESS SET
Command. 02DH
Function Plays, memorizes, and clears the track data
specified for muh_-access function
DATA I
DATAI 110.1) Instant playback of slot No l-
10
DATAI (10,1) 0AAH Loadlng the track
data mto the memory
DATAI (10,1) 0CCH Clearlngthesettmg
DATA1 (10.1)" 0FFH" Used for sense to
show the slot number currently played
RETURN command ADH
Notes
• Merely presemng usmg the command 25H
will not set the track data into memory. The
DATAI 0AAH of this command should be
executed to set the track data into memo_
before instant playback
• Clearmg the track data in the memoD' using
0CCH must be done while the MD deck is
stopped
• The sensing must be done dunng playback or
pause status
DATA I
DATA 1
000H AUTO PAUSE OFF
001H AUTO PAUSE ON
002H AUTO CUE ON
0FFH sense
RETURN command OBOH
AUTO DISPLAY SELECT
Command 03IH
Function - S_tches the display on the deck between
title display and the time display Since the title
and t,me are d,splayed simultaneously at all
times, the deck does not respond to this
command
DATA 1
DATA I
0FFH
(always returns 001H = AUTO
DISPLAY ON)
RETURN command 0B1H
END OF MESSAGE TIME
PRESET
AUTO PAUSE, AUTO CUE
SELECT
Command" 030H
Function
• AUTO PAUSE function
The PAUSE status is set at the beginning of next
track automatically when certain track _s
finishes playing This function is used when
you do not want continuous play or when you
want to locate a specific track but not to play it
immediately Also, this funenon is active in
repeat play or program play operanon
Further. the use of TRACK No LOCATE
command causes the PAUSE status to be set
,,,,,hen the specified
track is located
• AUTO CUE funcnon
When locating a track, ff there _s a silent part at
the beginning of track, this function skips that
part up to the sound rising part and pauses the
deck This funcuon ]s used m the PAUSE status
at the beginning of a track to adJuSt finely the
transmission of PLAY command with the sound
rising t_mmg
Command. 032H
Function Th_s function outputs the status from RS-
232C connector when the remammg ume up to
the end of track becomes several seconds
(settable range: I to 35 sec in the Track EOM
and 1 to 10 sec in the DRsc EOM) dunng
playing of a certam track
The use of this function enables control of other
external eqmpment, expecting the end of track
Note
To turn off this function, set the EOM to 000H
DATA t
DATA I
000H" EOM MODE OFF
If Track EOM is set
(10, 11 {*000 to 035, decimal number}
If Disc EOM is set (E, X)
X=0 one second before the end of the disc
X=I two seconds before the end of the disc
X=9 ten seconds before the end of the disc
0FFH EOM SENSE
RETURN command 0B2H
B
Appendix
A-1,5