Sony SLT-A37 Instruction Manual page 4

Note:
This equipment has been tested and %und
to comply with the limits for a (lass B
digital device, pursuant to Part 15 of the
FCC Rules.
These limits are designed to provide
reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses. and can
radiate radio lYequency energy and. if not
installed and used in accordance with tile
instructions, may cause harmful
interference to radio communications.
However. there is no guarantee that
interference will not occur in a particular
installation. If this equipment does cause
ham/fld interference to radio or television
reception, which can be determined by
turning the equipment off and on. tile user
is encouraged to try to correct tile
interlk.rence by one or morn of tile
following measures:
Reorient or relocate the receiving
antenna.
Increase file separation belween the
equipment and receiver.
Connect tile equipment into an outlet
on a circuit different from that to which
tile receiver is connected.
Consult tile dealer or an experienced
radio/TV technician %r help.
Tile supplied interface cable must be used
with tile equipment in order to comply with
tile limits for a digital device pursuant to
Subpart B of Part 15 of PCC Rules.
Noticeforthe customers in the
countries applyingEUDirectives
The manufacturer of this product is Sony
Corporation. 1_7-1 Konan Minato-ku
Tokyo, 108_0075 Japan. The Authorized
Representative %r EM( and product safety
is Sony Deutschland GmbH. Hedelfinger
Strasse 61. 70327 Stuttgart, Germany. For
any service or guarantee matters please
mlcr to the addresses given in separate
service or guarantee documents.
This product has been tested and %und
compliant with tile limits set out in tile
EMC Directive for using connection cables
shorter than 3 meters (9.8 feet).
Attention
The electromagnetic fields at the specific
lYequencies may influence the picture and
sound of this unit.
Notice
If static electricity or electromagnetism
causes data transfer to discontinue midway
(fail), restart tile application or disconnect
and connect tile communication cable
(USB, etc.) again.
DisposalofOld Electrical&
ElectronicEquipment ( Applicablein
the European Unionandother
Europeancountries with separate
collectionsystems)
This symbol on the product or on its
packaging indicates that this product shall
not be treated as household waste. Instead it
shall be handed over to tile applicable
collection point for the recycling of
electrical and electronic equipment. By
ensuring this product is disposed of
correctly, you will help prevent potential
:gative consequences for tile enviromnent
and human health, which could otherwise
be caused by inappropriate waste handling
of this product. The recycling of materials
will help to conserve natural resources. For
more detailed infommtion about recycling
of this product, please contact your local
(ivic Office, your household waste
disposal service or the shop where you
purchased the product.