Troubleshooting; Batteries And Power - Sony Cyber-shot DSC-S730 Instruction Manual

Troubleshooting
If you experience lrouble wilh ycmr camera, try the following solutions.
[ 0 Check the items below, and refer to "Cyber-shot Handbook" (PDF). ]
0 Remove the batteries, wait for about one minute, re-insert the batteries, then
turn on the power.
I° 1
[° ]
Be aware thai by sending tile camera for repair, you gixe consent that the contents of the
internal memory may be checked.
V
Initialize the settings (page 21).
Consult your Sony dealer or local authorized Sony service facility.
The battery remaining indicator is incorrect, or sufficient battery remaining
indicator is displayed but the power runs out too quickly.
• This phenomenon occurs _hen you use the camera in an extremely hot or cold location.
• When using alkaline batteries/Oxy Nickel Primary Battery (not supplied), the displayed time
remaining may not be correctly indicated.
• The batteries are discharged, hlsert new batteries or charged Nickel-Metal Hydride batteries
/not supplied) (page 9).
• When using the Nickel-Metal Hydride batteries, the poles of batteries or the terminals of the
battery cover are dirty so the batteries are not charged sufficiently. Clean Ihem with a cotton
swab, etc.
• When using the Nickel-Metal Hydride batteries, the displayed time remaining differs from the
current one due to the memory effccL etc. Fully discharge and then charge the batteries to
correct the display.
• The batteries are dead. Replace Ihem with new ones.
The batteries run down too quickly.
• You are using the camera in an extremely cold location.
• The batteries are dead. Replace Ihem with new ones.
• When using the Nickel-Metal Hydride batteries, charge them sufficiently.
Camera power is turned off automatically when you open the battery/"Memory
Stick Duo" cover.
• This is not a malfunction. Turn off the camera before you open the battery/"Memory Stick
Duo" cover.
27