Table of Contents
Advertisement
Running a Printer Check
You can run a printer check to determine whether a problem comes from
the printer itself or some other source. Follow these steps to run the
printer check:
1. Make sure both the printer and computer are turned off.
2. Disconnect the printer cable from the printer.
3. Make sure letter-size paper is loaded in the printer.
4. Hold down the E load/eject button, then press and release the
5. To end the check, turn off the printer after it prints the check page.
If the check page prints, the problem probably lies in your software
settings, the printer cable, or your computer.
If the check page doesn't print, you may have a problem with your printer.
Try the suggestions in "Problems and Solutions" beginning on page 41. If
nothing seems to work, contact your dealer or EPSON as described on
page 47.
40
Ppower button. Continue holding down the E load/eject button
until the Ppower light starts to flash, then release it.
One page is printed showing the ROM version number, ink counter,
and a nozzle check pattern. Only the nozzle check pattern is shown
below. (If the pattern is missing dots, you need to clean the print
head; see page 27.)
Then reconnect the printer cable and turn on your printer and
computer.
Advertisement
Table of Contents
