Table of Contents
Advertisement
5. Make sure the name of the hard disk on you would like to install
the programs is shown below the message "on the hard disk
named" (where HD-SCSI 0 appears in the example).
If the hard disk
6. Click Switch Disk. Then one of other hard disk names is
displayed. Click
name.
7. Click Install to perform the easy installation. The installer starts
copying the necessary files automatically.
8. Change the disk from Printing Tools (Disk1 ) to Screen Fonts
(Disk2) when the installer instructs you to do so. Installer
continues copying files automatically after you insert the next
disk.
Note:
You need to exchange the disks several times, as the messages
indicate.
9. Make sure the following message shows
10. Click Restart. You are
disk 3.
1-4
Installing the Programs
is correct, go to step 7.
name
until you see the desired hard disk
again
Installation on the active startup disk
"HD-SCSI 0" was successful. You must
now restart your Macintosh to use your
new software.
now
on
finished copying files from the
your display.
Advertisement
Table of Contents
